DDS-based Programmable Oscillator Module Model PCK-50AF
PCK-50AF is wide band clock source utilizing Direct Digital Synthesis technique.
It provides CMOS/TTL level clock output and analog output from 1Hz to 50MHz in 1Hz step.
The frequency can be controlled by parallel data such as DIP SW or a serial data
which can be connected to PC communication port. PCK-50AF can be used for both digital,
analog and RF signal source.
- Wideband(1Hz-50MHz) High resolution(1Hz)
- Single Power Supply +5V
- Frequency controlled by parallel and serial data
- Frequency stored in non-volatille memory
- CMOS/TTL level clock output and analog output
- High purity signal with low spurious
- Various clock source
- Numerically controlled oscillator
- Signal generator
- Sweep Oscillator
|Power Supply||+5V ±5%, 300mA|
|(100Hz-50,000,000Hz with 50ohm termination of analog output)|
1Vp-p ±20%(without termination)
0.5Vp-p ±20%(50ohm termination)
|Analog output impedance||50ohm|
|CMOS/TTL duty cycle||50% ±10%|
|Frequency Accuracy||± 20ppm, 0-50 degrees C|
|Spurious||-40dB(harmonics are excluded)|
|Analog output harmonics spurious||-35dB|
|Non-Voltile memory save times||more than 10,000|
Parallel input 6bits control lines
4-bit BCD input, 1 bit digit/data selection
1 bit strobe signal
Serial input, 2signal wires
9600 BPS,8bit, without parity
1 stop bit,
ASCII 9digit numeric data and delimitter.
|Frequency switching time||within 2mS(time from setting freq. data to getting signal)|
OPTION Frequency setting board FIX-50
Frequency setting board FIX-50 can be set frequency easily with BCD switches.
A frequency and setting value can be memorized with a save switch on the board.
When the module is used for itself, it is used as a memory setting tool of the parameter.
Just insert the module to the sockets of the board. Also, the detaching is easy.
For more information, click below.